Jumpers and Connectors Description Default J1 32-bit PCI (open - 64-bit PCI) Open J2 BIOS enable; (installed - BIOS disabled) Open J3 UART serial I/O connector for test (not present) Open J4 UART serial I/O connector for test (not present) Open J5 Serial I/O connector for Serial EPROM Open J6 I2C connector, used as the interface for the controller to communicate with a storage enclosure processor in an enclosure arrangement Open J7-J12 SATA port connectors (see Figure 3.2 in the Intel® RAID Controller SRCS16 Hardware User’s Guide for details) Connection depends on drives used J13 Mode 0 Select (closed - Mode 0), factory use only. Open J14 3.3 V load sharing (open - disable) Open J15 Battery backup daughter card connector (not used) Open J16, J17, JP1 Reserved for factory use Open

This applies to:

Intel® RAID Controller SRCS16